Tips for Cleaning Skateboard Bearings

Cleaning your skateboard bearings is a necessity if you want to maintain their optimum performance. You can use a Citrus cleaner or Isopropyl alcohol, as well as acetone. However, it is advisable to use a lubricant. It will prevent rusting and keep the bearings lubricated.

Isopropyl Alcohol

Most skateboarders will wash their skateboard bearings with acetone, but you should always use safety gloves when cleaning skateboard bearings. When using the solvent, you should make sure to remove the bearing shields first. Next, you should soak the bearings for a few hours or overnight, depending on how dirty they are. This process can take a few days.

After washing the bearings, place them in a clean, dry location. You can spin them a little part way to get rid of any excess fluid. Once the bearings are clean, you can lubricate them with skate lube and replace the protective shields.

Acetone

Acetone is an ideal solvent for cleaning skateboard bearings. It cleans the bearings without damaging them, and can also extend the life of the bearings. It can also reduce the noise made by the bearings. Afterwards, you can dry off the bearings using a paper towel.

If you're using acetone to clean your skateboard bearings, make sure to wear gloves and be careful to avoid contact with the solvent. You can also use mineral spirits or rubbing alcohol, which are both less harsh and more affordable. These solutions do not corrode the bearings, but they take longer to work.

You can also use compressed air to clean your bearings. This can be purchased at an electronics store or an office supply store. Just be sure to wear gloves so you don't get any solvent on your skin or eyes.

Isopropyl Alcohol Good

Isopropyl alcohol is a good solution for cleaning skateboard bearings. It is not recommended to use hot water when cleaning bearings. Once they are cleaned, use a hair dryer to dry them completely. You can also purchase a cleaning kit that contains a pole that space out the bearings. You should follow the directions on the kit to use the proper amount of fluid.

The first step in cleaning skateboard bearings is to check the bearings for dirt and grime. Dirty bearings will give you a grinding sound when you roll. You should also check the bearings for resistance when spinning them between your fingers. If you find that they do not spin after a second, they are most likely dirty.

Isopropyl Alcohol Bad

If you have a dirty skateboard bearing, you can use Isopropyl alcohol to clean it. Make sure you wear gloves while working with the solvent. Place your bearings in the alcohol and allow them to soak for several hours, overnight, or even several days. The alcohol needs to sit for a long time for the cleaning process to be effective.

After cleaning your skateboard bearings, make sure to dry them thoroughly. To dry your bearings, you can spin them or use canned air. After that, you should lubricate them with a light oil.